Filter
Top Products
Black Box Hardened Managed Ethernet Switch
4. Example:
The following example enables the spannin
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree autoedge
switch_a(config-if)#
g-tree autoedge of the interface
Edgeport:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Term
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt
switch_a(config)#interface fe1
switch_a(config-if)#
inal Mode).
will show on the screen.
2. Usage:
Use spanning-tree edgeport command t and to
enable rapid transitions.
Use the no spanning-tree edgeport command to set a port to its default
state (not an edge-port) and to disable rapid transitions.
3. Command Syntax:
(no) spanning-tree edgeport
4. Example:
The following example enables the spanning-tree edgeport of the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree edgeport
switch_a(config-if)#
set a port to its default
state (not an edge-port) and to disable rapid transitions.
3. Command Syntax:
(no) spanning-tree edgeport
4. Example:
The following example enables the spanning-tree edgeport of the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree edgeport
switch_a(config-if)#
o set a port as an edge-port
Ring Setting
Ring state:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable Ring state. Use the no parameter with this
command to disable Ring state.
3. Command Syntax:
bridge GROUP ring enable
116 User’s Manual