Filter
Top Products
Black Box Hardened Managed Ethernet Switch
802.1x
Radius Configuration, Port-Based Authentication
Radius Configuration
Radius Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Config
The switch_a(config)# prompt will show
switch_a(config)#
ure Terminal Mode).
on the screen.
2. Usage:
Use dot1x system-auth-ctrl command to globally enable authentication.
Use no dot1x system-auth-ctrl authentication.
3. Command Syntax:
(no) dot1x system-auth-ctrl
4. Example:
The following example globally enables authentication:
switch_a(config)#dot1x system-auth-ctrl
switch_a(config)#
command to globally disable
Radius Server IP:
Radius Server Port:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the IP address of the remote radius server host
and assign authentication and accounting destination port number.
3. Command Syntax:
(no) radius-server host IP-ADDRESS auth-port PORT
IP-ADDRESS A.B.C.D specifies the IP address of the radius server host.
PORT specifies the UDP destination port for authentication requests. The
host is not used for authentication if set to 0.
4. Example:
The following example specifies the IP address (192.168.1.100) of the
remote radius server host and assigns authentication and accounting
destination port number (1812):
136 User’s Manual