Filter
Top Products
Black Box Hardened Managed Ethernet Switch
switch_a(config)#radius-server host 192.168.1.100 auth-port 1812
switch_a(config)#
Secret Key:
1. Command Mode: Configure mode
Logon to Configure Mode (Config
The switch_a(config)# prompt will show
switch_a(config)#
ure Terminal Mode).
on the screen.
2. Usage:
Use this command to set the shared secre er and
a client.
3. Command Syntax:
(no) radius-server host IP-ADDRESS key Y
IP-ADDRESS A.B.C.D specifies t server host.
KEY specifies the secret key shared
802.1x client.
4. Example:
The following example specifies the IP address (192.168.1.100) of the
remote radius server host and set the secret key (ipi) shared among the
radius server and the 802.1x client:
switch_a(config)#radius-server host 192.168.1.100 key ipi
switch_a(config)#
IP-ADDRESS A.B.C.D specifies t server host.
KEY specifies the secret key shared
802.1x client.
4. Example:
The following example specifies the IP address (192.168.1.100) of the
remote radius server host and set the secret key (ipi) shared among the
radius server and the 802.1x client:
switch_a(config)#radius-server host 192.168.1.100 key ipi
switch_a(config)#
t key between a Radius serv
KE
he IP address of the radiushe IP address of the radius
among the radius server and the among the radius server and the
Timeout:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the number of seconds a Switch waits for a
reply to a radius request before retransmitting the request.
3. Command Syntax:
radius-server timeout SEC
no radius-server timeout
SEC <1-1000> The number of seconds for a Switch to wait for a server host
to reply before timing out. Enter a value in the range 1 to 1000.
4. Example:
The following example specifies 20 seconds for the Switch to wait for a server
host to reply before timing out:
User’s Manual 137