Filter
Top Products
Black Box Hardened Managed Etherne witch t S
VLAN
VLAN Mode Setting, 802.1Q VLAN Setting,
VLAN
802.1Q VLAN Setting
VLAN Database:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Term
The switch_a(config)# prompt will show
switch_a(config)#
802.1Q Port Setting, Port Based
inal Mode).
on the screen.
2. Usage:
Use vlan database command to enter the
3. Command Syntax:
vlan database
4. Example:
The following example changes to VLAN configuration mode from Configure
mode:
switch_a(config)#vlan database
switch_a(config-vlan)#
VLAN configuration mode.
Add VLAN/Delete VLAN:
1. Command Mode: VLAN Configure mode
Logon to Configure Mode (Configure Terminal Mode).
Logon to VLAN Configure Mode.
The switch_a(config-vlan)# prompt will show on the screen.
switch_a(config)#vlan database
switch_a(config-vlan)#
2. Usage:
This command enables or disables the state of a particular VLAN on a bridge
basis. Specifying the disable state causes all forwarding over the specified
VLAN ID on the specified bridge to cease. Specifying the enable state allows
forwarding of frames on the specified VLAN-aware bridge.
3. Command Syntax:
vlan VLANID bridge GROUP name VLAN_NAME state enable/disable
no vlan VLANID bridge GROUP
VLANID The VID of the VLAN that will be enabled or disabled on the bridge
<2-4094>.
GROUP <1-1> The ID of the bridge-group on which the VLAN will be
118 User’s Manual