Filter
Top Products
Black Box Hardened Managed Etherne witch t S
switch_a(config)#radius-server timeout
switch_a(config)#
20
Retransmit:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Termin
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
al Mode).
2. Usage:
Use this command to specify the number s the Switch transmits each
radius request to the server before giving up.
3. Command Syntax:
radius-server retransmit RETRIES
no radius-server retransmit
RETRIES <1-100> Specifies the retransm
1 to 100.
4. Example:
The following example specifies the retransmit value 12:
switch_a(config)#radius-server retransmit 12
switch_a(config)#
of time
it value. Enter a value in the range
Port-Based Authentication
Authentication State:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use dot1x reauthetication command to enable reauthentication on a port.
Use no dot1x reauthetication command to disable reauthentication on a
port.
3. Command Syntax:
(no) dot1x reauthentication
4. Example:
The following example specifies to enable reauthetication on the interface fe1
(port 1):
138 User’s Manual