Filter
Top Products
Black Box Hardened Managed Ethernet Switch
The switch_a(config-if)# prompt will show
switch_a(config)#interface fe1
switch_a(config-if)#
on the screen.
2. Usage:
Use this command to set the port priorit ty
indicates a greater likelihood of the bridge becoming root.
3. Command Syntax:
bridge GROUP priority PRIORITY
GROUP <1-1> the ID of the bridge group.
PRIORITY <0-240> The priority to be assi
4. Example:
The following example sets the priority P
(port 1) of bridge GROUP (1):
switch_a(config)#interface fe1
switch_a(config-if)#bridge 1 priority 100
switch_a(config-if)#
y for a bridge. The lower priori
gned to the group.
RIORITY (100) of the interface fe1
Admin. Path Cost:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set the cost of a path associated with a bridge-group.
Use the no parameter with this command to restore the default cost of a path
associated with a bridge-group.
3. Command Syntax:
bridge GROUP path-cost PATHCOST
no bridge GROUP path-cost
GROUP <1-1> the ID of the bridge group.
PATHCOST <1-200000000> The cost to be assigned to the group.
4. Example:
The following example sets the cost (123) of the interface fe1 (port 1) of
bridge GROUP (1):
switch_a(config)#interface fe1
switch_a(config-if)#bridge 1 path-cost 123
switch_a(config-if)#
114 User’s Manual