Filter
Top Products
Black Box Hardened Managed Ethernet Switch
Point to Point Link:
1. Command Mode: Interface mode
Logon to Configure Mode (Config
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will sho
switch_a(config)#interface fe1
switch_a(config-if)#
ure Terminal Mode).
w on the screen.
2. Usage:
Use spanning-tree link-type type of a port to
enable or disable rapid transition.
Use the no spanning-tree link-type co ort to its default
state and to disable rapid transition.
3. Command Syntax:
(no) spanning-tree link-type LINKTYPE
LINKTYPE The link type to be assigned to the port.
point-to-point Enable rapid transition.
shared Disable rapid transition.
4. Example:
The following example sets the link-type LINKTYPE (point-to-point) of the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree link-type point-to-point
switch_a(config-if)#
YPE The link type to be assigned to the port.
point-to-point Enable rapid transition.
shared Disable rapid transition.
4. Example:
The following example sets the link-type LINKTYPE (point-to-point) of the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree link-type point-to-point
switch_a(config-if)#
command to set the link
mmand to set a p
Autoedge:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use spanning-tree autoedge command to assist in automatic identification
of the edge port.
Use the no spanning-tree autoedge command to disable this feature.
3. Command Syntax:
(no) spanning-tree autoedge
User’s Manual 115