Filter
Top Products
Chapter 3 Registering Information in the MultiPASS C70 3-3
Registering Information
in the MultiPASS C70
Guidelines for Entering Information Via the
Operation Panel
The following section provides a brief overview of how to use the
buttons on the operation panel to access menus, make selections, and
register your entries. You will also find information on entering
numbers, letters, and symbols to register fax/telephone numbers and
names.
When entering information, always keep the following points in mind:
❏ If you pause while entering information and do not make an entry
for more than 60 seconds, the MultiPASS C70 returns automatically
to standby mode and loses all information you had entered up to
that point. You will have to start again.
❏ If the MultiPASS C70 is set for manual receiving and the unit rings
while you are entering information, press the Stop button and lift
the handset or the handset of the telephone or extension phone. The
MultiPASS C70 will automatically save all the information entered
up to the last time you pressed the Set button.
• If you hear nothing or a slow beep, someone is trying to send a
fax: press the Start/Scan button on the MultiPASS C70 or dial 25
(remote receiving ID) on the telephone or extension phone to
activate reception of the fax. Then hang up the handset.
(1 Receiving a Fax Manually, p. 8-14)
• If you hear a voice, you are receiving a normal telephone call.
• If your MultiPASS C70 is set to receive faxes automatically, you
do not have to press the Stop button. The MultiPASS C70 will
automatically receive the fax.