Filter
Top Products
User Command Specifications 9. Details of command TRACK
1
TRACK
TRACK
TRACK=<Adjustment value: Number
>
Adjustment value
-1
A "busy" response is given while the zoom or focus lens is being driven.
Furthermore, it may not be possible to execute the command with some input signals.
-2
Menu
[Display settings] - [Input signal settings] - [Tracking]
[Display settings] - [Input signal settings] - [Tracking]
-3
Setting
> TRACK=25 The tracking adjustment value is set to 25.
< i:OK
Reference
> GET TRACK or ?TRACK This retrieves the tracking adjustment setting value.
< g:TRACK=21
Obtain settable parameter range (Min, Max)
> RANGE TRACK
< r:TRACK=N, 0, 31 Any value from 0 to 31 can be set for the tracking.
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
For details, refer to the GET command.
Command
s
supported
Mode Control Setting Reference
SX6
SX60
X600
The GET command can be used to retrieve the current tracking adjustment values.
Example
Commands
Function
Parameter
Description
Response
Model
SX50
Tracking adjustmen
t
"i:OK" is returned if the parameter was set properly.
This is used for adjustment when tracking (synchronization) is out of sync and the screen flickers.
This command is the same as the menu functions in the table below.
Number
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
The RANGE command can be used to obtain the parameter range that can be set at
that time.
01.00** 01.01** 01.01** 01.01**
SX50
○○
SX6 SX60 X600
Model Power
Input Mode
Remote Local
○○
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
× ○○×××––×○ ×
SX6
× ○○××××××○ ×
SX60
X600
Format
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
PAGE 22