Filter
Top Products
User Command Specifications 9. Details of command NOSHOW
1
NOSHOW
NOSHOW
NOSHOW=<Parameters for setting display screen in no show status ：ＩＤ>
Parameters for setting display screen in no show status
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Display settings] - [User screen settings] - [Screen in no show status]
[Display settings] - [User screen settings] - [Screen in no show status]
-3
-4
Setting
> NOSHOW=LOGO This sets the “User” screen when nothing is displayed.
<Ok
Reference
>
GET NOSHOW or ?NOSHOW This retrieves the screen shown when nothing is displayed.
< g:NOSHOW=LOGO
Acquisition of parameters which can be set
> RANGE NOSHOW
< r:NOSHOW=BLACK,BLUE,LOGO
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
For details, refer to the GET command.
"BLACK," "BLUE" or "LOGO" can be set for the display
screen in the no show status.
01.00** 01.01** 01.01**
SX6
SX60
X600
The GET command can be used to obtain the current display screen when nothing is shown.
"i:OK" is returned if the parameter was set properly.
This command is used to set the screen which is to appear in the no show status.
Model
SX50
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
Commands
Function
Parameter
Display screen setting when nothing show
n
Mode Control ReferenceSetting
Example
SX50 SX6 SX60 X600
Model Power
Input
LocalSCART None
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
Mode
Remote
SX50
○○○○○○–
○
–×
SX6
○○○○○○
SX60
X600
×○○○
○○
Format
Paramete
r
Black screenBLACK
LOGO User screen
ID
For details, refer to the RANGE command.
○○○
01.01**
○
Meaning
Response
Command
s
supported
Description
BLUE Blue screen
For all other responses, refer to "Error List."
This command is the same as the menu functions in the table below.
To select the user screen (LOGO), the user image must be registered ahead of time. (If the
user image is not registered, "e:1002 NO_LOGO_CAPTURED" is returned.)
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
PAGE 56