Filter
Top Products
User Command Specifications 9. Details of command PJON
1
PJON
PJON
PJON=<Parameters for setting display screen at startup;ＩＤ>
Parameters for setting display screen at startup
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Display settings] - [User screen settings] - [Screen at startup]
[Display settings] - [User screen settings] - [Screen at startup]
-3
-4
Setting
> PJON=CANON This sets the startup screen to “Canon logo”.
< i:OK
Reference
>
GET PJON or ?PJON This retrieves the startup screen.
< g:PJON=SKIP
Acquisition of parameters which can be set
> RANGE PJON
< r:PJON=I, CANON, SKIP, LOGO
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
01.00** 01.01** 01.01**
The GET command can be used to obtain the current screen displayed at startup.
This command is the same as the menu functions in the table below.
To select the user screen (LOGO), the user image must be registered ahead of time. (If the
user image is not registered, "e:1002 NO_LOGO_CAPTURED" is returned.)
SX6
SX60
For details, refer to the GET command.
Model
SX50
(Refer to the ZCONTDRV command and FCONTDRV command.)
X600
Commands
Function
Parameter
Display screen at startup settin
g
Mode Control Setting Reference
Description
SKIP No display
For all other responses, refer to "Error List."
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
"i:OK" is returned if the parameter was set properly.
This sets the screen displayed at startup.
Example
SX50 SX6 SX60 X600
"CANON," "SKIP" or "LOGO" can be set for the display
screen at startup.
Command
s
supported
○○○○
01.01**
Model Power
Input Mode
Remote LocalSCART None
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
SX50
○○○○○○–– ×
SX6
○○○○○○ ○
SX60
X600
×○○○
○○
Format
Paramete
r
Canon log
o
CANON
LOGO User screen
ID
Meaning
Response
PAGE 54