Filter
Top Products
28-4
User Guide for Cisco Digital Media Manager 5.4.x
OL-15762-05
Chapter 28 Emulate the DMP Remote Control for Use with Cisco Cast
Procedures
Procedures
In Cisco Unified Communications Manager
•
Activate Services, page 28-4
•
Start Services, page 28-5
•
Configure URL Parameters, page 28-5
•
Enable IP Phone Autoregistration, page 28-6
•
Define IP Phone Service Attributes, page 28-6
•
Expose the Service to IP Phones, page 28-7
In Cisco Cast
•
Configure Emulator Settings in Cast, page 28-8
On Phones
•
Configure an IP Phone to Emulate the Remote Control, page 28-10
•
Start the Emulator on an IP Phone, page 28-10
•
Start the Emulator on a Mobile Phone, page 28-11
•
Use the Emulator on an IP Phone or a Mobile Phone, page 28-12
Activate Services
Procedure
Step 1
Log in to Cisco Unified Communications Manager Administration.
Step 2
Choose Cisco Unified Serviceability from the Navigation list. Then, click Go.
Step 3
Choose Tools > Service Activation.
Step 4
Examine the Server list.
Step 5
Choose from it a server that should support remote control emulation.
Step 6
Click Go.
Step 7
Check the Check All Services check box.
Step 8
Click Save. Then, click OK.
Step 9
Stop. You have completed this procedure.
What to Do Next
•
Proceed to the “Start Services” section on page 28-5.