Filter
Top Products
28-9
User Guide for Cisco Digital Media Manager 5.4.x
OL-15762-05
Chapter 28 Emulate the DMP Remote Control for Use with Cisco Cast
Procedures
Step 5
Choose an option from the Security PIN behavior list.
Although Cisco Cast randomly generates all of its emulator PINs, the fixed and dynamic types differ in
their persistence.
•
Fixed—These PINs persist until the PIN management type is changed.
•
Dynamic—These PINs expire and are then regenerated after an update interval that you define.
No two DMPs in your network will use the same PIN at any one time.
Step 6
(As Needed) Did you choose the dynamic PIN type in Step 5?
If so, enter at least one digit in the Security PIN update interval (minutes) field.
The interval cannot be any less than 2 min. When you do not enter any value, Cisco Cast uses its
factory-default interval of 5 min.
Step 7
Enter a shortened URL in the Access URL field for a page that will redirect ultimately to
http://<DMM_hostname>:8080/etv-remotecontrol-webapp/app/index.htm.
Note The shortened URL must not be more than 24 characters long.
Step 8
Click Save.
OR
Click Cancel to discard your selections and start over again.
Step 9
Deploy the new emulator settings to your DMPs.
a.
Click Content Management on the Home page.
b.
Choose Digital Media Players > DMP Manager.
c.
Choose the DMP or DMP group that should use these settings.
d.
Choose Cast from the Actions list. Then, click Go.
Step 10
Stop. You have completed this procedure.
Related Topics
•
Workflow to Provision Emulator Service for IP Phones, page 28-3
•
Configure an IP Phone to Emulate the Remote Control, page 28-10
•
Start the Emulator on an IP Phone, page 28-10
•
Start the Emulator on a Mobile Phone, page 28-11
•
Use the Emulator on an IP Phone or a Mobile Phone, page 28-12