Filter
Top Products
28-8
User Guide for Cisco Digital Media Manager 5.4.x
OL-15762-05
Chapter 28 Emulate the DMP Remote Control for Use with Cisco Cast
Procedures
What to Do Next
•
Proceed to the “Configure Emulator Settings in Cast” section on page 28-8.
Related Topics
•
Enable IP Phone Autoregistration, page 28-6
Configure Emulator Settings in Cast
Note Options on the Remote Control page might sometimes be dimmed and not available to you.
• Click Save to activate dimmed options if this occurs during Step 1.
• This occurs during Step 2 only when your choice is None. Choose either All DMPs or Selected DMPs to reactivate options
that your choice dimmed.
Before You Begin
•
Complete the workflow in Cisco Unified Communications Manager to provision the emulator to
your IP phones.
Procedure
Step 1
Click Content Management.
Step 2
Choose Cast > Remote Control.
Step 3
Choose an option from the Display Security PIN on screen list, to set how many of your DMPs should
support the emulator.
•
All DMPs
•
Selected DMPs
•
None
Note We do not support remote control emulation on a DMP 4310G.
Step 4
(As Needed) Did you choose Selected DMPs in Step 3?
If so, click Display DMP Selections to refine your list of which DMPs should support the emulator.
a.
Use check boxes to select and deselect DMPs.
b.
Click Save Selection Changes to save your work.
c.
Click Close to dismiss the dialog box.