Filter
Top Products
132 Adding and Replacing Parts
www.dell.com | support.dell.com
To add or replace a memory module in the DIMM B connector:
NOTICE: If you need to install memory modules in two connectors, install a memory module in the
connector labeled “DIMMA” before you install a module in the connector labeled “DIMMB.” Insert
memory modules at a 45-degree angle to avoid damaging the connector.
1
Follow the procedures in "Before You Begin" on page 123.
2
Turn the computer bottom-side up, loosen the captive screw in the memory module cover,
and then remove the cover.
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-
module securing clips.
3
If you are replacing a memory module, ground yourself and remove the existing module:
a
Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector until the module pops up.
b
Remove the module from the connector.
1
memory module cover
2
captive screw
1
2