Filter
Top Products
108
18
BASIC IP COMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name
32> |state [enable | disable]} bootp |dhcp]
show ipif <ipif_name 12>
Each command is listed, in detail, in the following sections.
config ipif
Purpose Used to configure the System IP interface.
Syntax
config ipif <ipif_name 12> [{ ipaddress <network_address>
[ vlan <vlan_name 32> | state [enabled | disabled]} | bootp |
dhcp]
Description This command is used to configure the System IP interface on the
switch.
Parameters <ipif_name 12> Enter an alphanumeric string of up to 12 characters
to identify this ip interface.
<network_address> − IP address and netmask of the IP interface to
be created. You can specify the address and mask information
using the traditional format (for example, 10.1.2.3|255.0.0.0 or in
CIDR format, 10.1.2.3|8).
<vlan_name 32> − The name of the VLAN corresponding to the
System IP interface.
state [enable | disable] − Allows you to enable or disable the IP
interface.
bootp − Allows the selection of the BOOTP protocol for the
assignment of an IP address to the switch’s System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment
of an IP address to the switch’s System IP interface.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the IP interface System: