Filter
Top Products
53
9
NETWORK MONITORING COMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilitzation [cpu | ports {<portlist>}]
clear counters ports <portlist>
clear log
show log index <value_list>
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress <ipaddr> {severity
[informational|warning|all]| facility[local0|local1|local2|local3|
local4|local5|local6|local7] |udp_port<udp_port_number>|
state[enable|disable]
config syslog host
[all | <index 1-4>] {severity [informational | warning |all] |facility
[local0|local1|local2|local3|local4|local5|local6|local7] |udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable |
disable]}
delete syslog host
<index 1-4>
all
show syslog host
<index 1-4>
Each command is listed, in detail, in the following sections.
show packet ports
Purpose Used to display statistics about the packets sent
and received by the switch.
Syntax
show packet ports <portlist>
Description This command is used to display statistics about
packets sent and received by ports specified in
the port list.
Parameters
<portlist> − specifies a port or range of ports to
be displayed.
Restrictions None.
Example usage:
To display the packets analysis for port 7 of module 2: