Filter
Top Products
193
reconfig
switch the user desires to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To connect to the MS, with member id 2, through the CS, using the command line interface:
DES-3550:4#reconfig member_id 2
Command: reconfig member_id 2
DES-3550:4#
Login:
config sim
Purpose Used to configure the SIM role of the switch and its corresponding
parameters.
Syntax
config sim [{[commander { group_name <groupname 64> |
candidate] | dp_interval <sec 30-90 | hold_time <sec 100-300>}]
Description This command is used to add candidates and delete members from
the SIM group by id number.
Parameters commander – Use this parameter to configure the commander
switch for the following parameters:
group_name <groupname 64> - Used to update the name of
the group. Enter an alphanumeric string of up to 64
characters to rename the SIM group.
dp_interval – The user may set the discovery protocol
interval, in seconds that the switch will send out discovery
packets. Returning information to the commander switch will
include information about other switches connected to it.
(Ex. MS, CaS). The user may set the dp interval from 1 to 60
seconds.
hold time – Using this parameter, the user may set the time,
in seconds, the switch will hold information sent to it from
other switches, utilizing the discovery interval protocol. The
user amy set the hold time from 1 to 180 seconds.
candidate – Used to change the role of a commander switch to a
candidate switch.
dp_interval – The user may set the discovery protocol
interval, in seconds that the switch will send out discovery
packets. Returning information to the commander switch will
include information about other switches connected to it.
(Ex. MS, CaS). The user may set the dp interval from 1 to 60
seconds.