Filter
Top Products
126
config 802.1x auth_parameter
•
auto − Allows the port’s status to reflect the outcome of the
authentication process.
•
force_unauth − Forces the Authenticator for the port to
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535>
−
Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait
for a response from a Radius server.
max_req <value 1-10> − Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535>
−
Configures the time interval
between successive re-authentications.
enable_reauth [enable|disable] − Determines whether or not the
switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
DES-3550:4#config 802.1x auth_parameter ports 1–20 direction
both
Command: config 802.1x auth_parameter ports 1–20 direction
both
Success.
DES-3550:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> |all] {mac_address <macaddr>}]
Description
The
config 802.1x init
command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC