Filter
Top Products
24
6
PORT SECURITY COMMANDS
The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config port_security
ports
[<portlist>| all ] {admin_state [enable| disable]
|max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
delete port_security
entry
vlan_name <vlan_name 32> mac_address <macaddr> port <port>
clear
port_security_entry
port <portlist>
show port_security {ports <portlist>}
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Used to configure port security settings.
Syntax config port_security ports [<portlist>| all ] {admin_state [enable|
disable] | max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
Description
This command allows for the configuration of the port security feature.
Only the ports listed in the <portlist> are effected.
Parameters
portlist − specifies a port or range of ports to be configured.
all − configure port security for all ports on the switch.
admin_state [enable|disable] – enable or disable port security for the listed
ports.
max_learning_addr <max_lock_no 0-10> - use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
lock_address_mode[Permanent | DeleteOnTimout | DeleteOnReset] –
Indicates the method of locking addresses. The user has three choices:
Permanent – The locked addresses will not age out after the
aging timer expires.
DeleteOnTimeout – The locked addresses will age out after the
aging timer expires.
DeleteOnReset – The locked addresses will not age out until the
switch has been reset.
Restrictions
Only administrator-level users can issue this command.
Example usage: