Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 25
Main Menu — Analyzer and I/O-module expert configuration
↓↓
Analyzer module setup
↓↓
Range parameters
↓↓
In the menu "Range parameters" and its submenus you can set up and control range
parameters like
♦ begin and end of range
♦ response time (t
90
-time)
♦ autoranging
for one channel. You can change to the other channels of an MLT analyzer or analyzer
module with the F3 key.
Parameters setup or changing to submenus:
♦ Select any line of variables or any menu line with the ↓↓ -key or the ↑↑ -key.
♦ Select the variable or change to the submenu with the 88 -key or the →→ -key.
♦ Select the parameter with the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new setup with the 88 -key or
cancel and go back to the last setup with the F2 key.
Line of variables "Range control":
The parameter selected in this line is valid for the autoranging control of the current
channel (see p. 5-29). You have the following options:
Measure Channel Back...
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Range parameters --
Begin and end of ranges...
Autoranging control...
Range control: Manual
Actual range number: 1
Response times (t90)...
5.1 Analyzer Module Setup
5.1.3 Range parameters