Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 1
If you press the 88 -key or the →→ -key in the line "Analyzer and I/O-module expert
configuration..." of the "Main Menu", you will change to the following display:
From the menu "Expert Module Configuration" you can change to several submenus to
set up parameters for the measurement and calibration of your analyzer and analyzer
module. Besides you can set up the configuration for auxiliary modules. Which part of
these menus are important for you depends on the configuration of your NGA 2000
system.
In the following table you will find a short overview about the contents of the menus:
Menu Important Contents Section/Page
Analyzer module controls... ⇒ See "Analyzer module setup" and note below!
I/O module controls...
⇒ Configuration of the SIO and of the DIO's
installed in a platform or
in an MLT analyzer (auxiliary I/O's)
∗ 5.2
p. 83 - 98
Analyzer module setup...
⇒ Measurement set up and control
⇒ Calibration set up and control
⇒ Configuration of the SIO and of the DIO's
installed in the MLT analyzer module
(Local SIO/DIO)
⇒ Programmable logic control (PLC)
⇒ Programmable calculators
∗ 5.1
p. 3 - 82
I/O module setup...
⇒ Set up for micro processor controlled
auxiliary I/O modules
∗ 5.3 / p. 99
Note:
All submenus of "Analyzer module controls..." are the same like those of "Analyzer module
setup...", if you use an MLT analyzer or analyzer module (resp. TFID analyzer or analyzer
module)! If your analyzer is not such a type, the submenus of "Analyzer module
controls..." and "Analyzer module setup..." will look different, partially. Look at the
corresponding software manuals.
Measure Channel Back...
TAG
F1 F2 F3 F4 F5
37.50 ppm
-- Expert Module Configuration --
Analyzer module controls...
Analyzer module setup...
I/O module setup...
I/O module controls...
5 Analyzer and I/O-Module Expert Configuration