Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 43
Start the program with "Enabled" in the line "PLC is" of the menu "Programmable Logic
Control". Then, control the output status in the submenu "PLC Outputs". You will reach
this menu via the line "Results..." in the menu "Programmable Logic Control":
In the display shown above the output 1 is "On". That means for the example described:
The zero gas calibration of channel 1 or 2 or
the span gas calibration of channel 3 is still running.
Note:
Via the F5 key (More...) you can reach another menu page with the results of the plc
outputs 11 to 20.
Measure Back...
TAG
F1 F2 F3 F4 F5
0.00 ppm
-- PLC Outputs --
Out -3: Off
Out -4: Off
Out -5: Off
Out -6: Off
Out -7: Off
Out -9: Off
Out -10: Off
Out -2: Off
Out -8: Off
Out -1: On
More...
5.1 Analyzer Module Setup
5.1.6 Programmable Locic Control (PLC)