Filter
Top Products
NGA-2000 System Calibration
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98 NGA 2000 Supplement - 15
The result of calibration for included AMs is displayed in an own menu page. This can be
achieved by softkey „Result...“ from different menu pages of SYSCAL.
SCMODULE
SCCONTROL
SCLRESULT
SCVALIDITY
SCRESULT1
SCRESULT2
Remember to run the calibration procedures as a test without actually to calibrate assert
parameter "Calibration Procedures in Test-Mode" to <Yes>.
It is also possible to switch for test purposes onto a special gas of a specific module. This
possibility is located in menu "Test procedures".
SCTESTGAS
SCTIMEOUT
SCCALTIME1
SCSTEPMOD
- Calibration Results -
Choose analyzer module...
Analyzer-module: CLD
Enabled for system-cal: No
_______________________________________________
Result of last run: OK
Successfully calibrated ranges: 1+2+4
Zero-Cal fail of any analyzer module: NO
Span-Cal fail of any analyzer module: YES
System configuration and diagnostics...
↓
System Calibration...
↓
Calibration/Test Procedures...
↓
Test procedures...
↓
-- Test Procedures --
Gastest of specific module SAMPLE-Gas
Timeout for Gastest (0 = no timeout) 180 s
Choose specific analyzer module...
_______________________________________________
Procedure time: 10 s
Analyzer-module: MLT/CH3