Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 55
Main Menu — Analyzer and I/O-module expert configuration
↓↓
Analyzer module setup
↓↓
Peak measurement
↓↓
In the menu "Concentration Peak Measurement" you can determine the conditions for the
extreme values of a channel. If you want to change to the other channels of an MLT
analyzer or analyzer module, you have to press the F3 key.
Set up parameters:
♦ Select any line of variables or any function line with the ↓↓ -key or the ↑↑ -key.
♦ Select the variable or start the function with the 88 -key or the →→ -key.
♦ If asked after function start: Confirm with the F2 key (Yes) or
cancel and go back to the menu page with the F4 key (Back...) or the ←← -key.
♦ Variable changing: Select the parameter with the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new parameter with the 88 -key or
cancel and go back to the last adjustment with the F2 key.
Function lines "Reset minimum !" or "Reset maximum !"
Starting these functions will reset the last minimum or maximum value of concentration.
This is necessary to start a new minimum or maximum determination.
Function line "Reset both !"
Starting this function will reset the last minimum and the last maximum value of con-
centration simultaneously.
Measure Channel Back...
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Concentration Peak Measurement --
Reset minimum !
Reset both !
Minimum detection: Always
Maximum detection: Always
Last minimum: 93.400
Last maximum: 95.900
Reset maximum !
Difference (Max-Min): 2.500
5.1 Analyzer Module Setup
5.1.11 Concentration Peak Measurement
[2nd menu page via F5 (More...)]