Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 51
"Tags...":
Via the F5 key (Tags...) you can change to the second page of the menu "Measurement
Display Configuration". There you can adjust the identification tag of the MLT analyzer or
analyzer module and the tag of each range for the current channel. These range tags will
appear at the top left of each menu page display. If you want to change the tags of the
other channels, you have to press the F3 key.
Caution:
If you change the identification tag, you have to change the configuration of the
programmable digital inputs and analog outputs. Because, the parameters of the
module source will change ! So, the relations will disappear !
Tags set up:
♦ Select the line you want with the ↑↑ -key or ↓↓ -key.
♦ Select the parameter with the 88 -key or the →→ -key.
♦ Select the digit you want to change with the →→ -key or the ←← -key and adjust the new
value with the ↑↑ -key or the ↓↓ -key;
Maximum of digits for each tag: 30
Options: alphabet (capital and small letters), umlauts, letters from different languages,
0, 1, 2,..., 9, +, -, *, /, =, ?, !, %, $ and many others.
♦ Confirm the new value with the 88 -key or
cancel and go back to the last value with the F2 key.
Notes:
♦ The changes of the range tags will be realized after you have changed the range
for the first time !
♦ You can set up the digits more fast by holding the ↑↑ -key or the ↓↓ -key.
The scrolling will accelerate.
Measure Channel Back...
MLT25/CH2/R2
F1 F2 F3 F4 F5
95.00 ppm
-- Measurement Display Configuration (2/2) --
Module identification tag: MLT25/CH2
Tag for range 2: MLT25/CH2/R2
Tag for range 3: MLT25/CH2/R3
Tag for range 4: MLT25/CH2/R4
Tag for range 1: MLT25/CH2/R1
5.1 Analyzer Module Setup
5.1.8 Measurement Display Configuration