Filter
Top Products
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
5 - 75
Function line "Reset output fail !"
The 24 digital outputs are composed of 3 units with 8 outputs. If there is a short circuit or
an overload in one unit, it will be switched off and saved against destruction. After the
defect is removed, the board is available immediately. You only have to press the 88 -key
or the →→ -key in the line "Reset output fail !". If asked: Confirm with F2 key (Yes).
Informations about the whole specification of the DIO board you will find in another manual.
The last four lines of variables:
These lines display the board status, the slot number and the gear status of the DIO board
selected. The lines are not available.
Signal Codes 1 - 359
Available for:
♦ SIO relay outputs (see p. 5-73)
♦ DIO outputs (see p.5-74)
♦ Programmable logic control (see 5.1.6 p. 5-37)
General Signals
Signal ID Signal
1 RAM-Fail
2 ROMFail
3 Seconds; LOW/HIGH change all 1000 ms
4 Any sample gas valve selected (Channel 1...5)
5 Any zero gas valve (Channel 1...5)
6 Any span gas valve Selected (Channel 1...5)
7 NAMUR-status: Failure (Channel 1...5)
8 NAMUR-status:Maintenance Request (Channel 1...5)
9 NAMUR-status:Function Control (Channel 1...5)
10 - 19 Reserved
Programmable Calculator
Signal ID Signal
20 Execution status
21 Result 1 / Limit 1
22 Result 1 / Limit 2
23 Result 1 / Limit 3
24 Result 1 / Limit 4
25 Result 2 / Limit 1
26 Result 2 / Limit 2
27 Result 2 / Limit 3
28 Result 2 / Limit 4
29 Result 3 / Limit 1
30 Result 3 / Limit 2
31 Result 3 / Limit 3
32 Result 3 / Limit 4
33 Result 4 / Limit 1
34 Result 4 / Limit 2
35 Result 4 / Limit 3
36 Result 4 / Limit 4
37 - 39 Reserved