Filter
Top Products
5 - 84
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
Main Menu — Analyzer and I/O-module expert configuration
↓↓
I/O module controls
↓↓
SIO module
↓↓
From the menu "SIO - Configuration Parameters" you can change to submenus to control
and set up several output configurations of the auxiliary SIO module.
General Configuration of a SIO board (for the whole specification see its own manual):
♦ Analog outputs: minimum 2, maximum 8
♦ Serial interface (RS 232 or RS 485) to connect the analyzer with an external computer
♦ Three relay outputs
If there is a SIO module installed in the platform or in the MLT analyzer, you have to put in
"Yes" in the line "Module installed", otherwise "No".
Set up parameters:
♦ Select the line of variables or any menu line with the ↓↓ -key or the ↑↑ -key.
♦ Select the variable or change to the submenu with the 88 -key or the →→ -key.
♦ Select the parameter with the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new adjustment with the 88 -key or
cancel and go back to the last value with the F2 key.
Measure
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- SIO-Configuration Parameters --
Analog output setup...
Serial interface setup...
Configuration of Relay Outputs...
Module installed: Yes
Back...
5.2 I/O Module Controls
5.2.1 SIO Module