Filter
Top Products
5 - 74
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
Main Menu — Analyzer and I/O-module expert configuration
↓↓
Analyzer module setup
↓↓
Inputs and outputs
↓↓
DIO-module(s)
↓↓
In the menu "Local DIO Boards Setup" you can set up the configuration of the local DIO
modules of the analyzer module. Each DIO module is composed of 8 digital inputs and 24
digital outputs. You can attach a function to each input (e.g. opening of a valve) and a
signal to each output (e.g zero valve) by a corresponding code.
See the tables on the following pages:
++ Signal codes 1 -359: see p. 5-75 to 5-77; Function codes: 1 - 599 see p. 5-78 !
Set up parameters:
♦ Select the line of variables or the function line with the ↓↓ -key or the ↑↑ -key.
♦ Select the variable or start the function with the 88 -key or the →→ -key.
♦ If asked after function start: Confirm with the F2 key (Yes) or
cancel and go back to the menu page with the F4 key (Back...) or the ←← -key.
♦ Variable changing:
Select any digit with the ←← -key or the →→ -key and adjust a new value with
the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new value with the 88 -key or
cancel and go back to the last value with the F2 key.
Measure Back...NEXT_DIO
TAG
F1 F2 F3 F4 F5
95.00 ppm
-- Local DIO Boards Setup --
Number of selected input: 1
Number of selected output: 1
- Signal code: 111
Reset output fail !
Board status: Normal
Current status of selected input: Low
Current status of selected output: High
- Function code: 13
Slot number of selected board: 6
5.1 Analyzer Module Setup
5.1.18 Inputs and Outputs – Local DIO
[2nd menu page via F5 (More...)]