Filter
Top Products
NGA 2000
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
5 Analyzer and I/O-Module Expert Configuration 5 - 1
5.1 Analyzer Module Setup 5 - 3
5.1.1 Calibration Parameters...................................................................................5 - 5
– Span gases .........................................................................................5 - 6
– Tolerances ..........................................................................................5 - 7
– Calibration procedure setup ................................................................5 - 9
– Time controlled calibration ..................................................................5 -12
– Calibration...........................................................................................5 -15
– Advanced calibration methods ............................................................5 -18
– Zero gases ..........................................................................................5 -20
5.1.2 Alarm Parameters...........................................................................................5 -21
5.1.3 Range Parameters .........................................................................................5 -25
– Begin and end of ranges.....................................................................5 -27
– Response times (t
90
) ...........................................................................5 -28
– Autoranging control .............................................................................5 -29
5.1.4 Cross Interference Compensation..................................................................5 -31
5.1.5 Linearization ...................................................................................................5 -33
5.1.6 Programmable Logic Control (PLC)................................................................5 -37
5.1.7 Programmable Calculator...............................................................................5 -45
5.1.8 Measurement Display Configuration...............................................................5 -49
5.1.9 Acknowledgement of Status Reports..............................................................5 -52
5.1.10 Concentration Measurement Parameters.......................................................5 -54
5.1.11 Peak Measurement ........................................................................................5 -55
5.1.12 Differential Measurement ...............................................................................5 -57
5.1.13 Gasflow Setup ................................................................................................5 -59
5.1.14 Pressure Compensation .................................................................................5 -60
5.1.15 Flow Measurement .........................................................................................5 -62
5.1.16 Temperature Measurement............................................................................5 -63
5.1.17 Loading/Saving Configuration Parameters.....................................................5 -64
5.1.18 Inputs and Outputs .........................................................................................5 -67
– Local SIO ............................................................................................5 -68
– Local DIO ............................................................................................5 -74
– Signal codes........................................................................................5 -75
5.1.19 Delay and Average .........................................................................................5 -79
5.1.20 Special Functions ...........................................................................................5 -81
5.1.21 AK-Protocol Communication ..........................................................................5 -82
II