Filter
Top Products
3 Startup and Operation, General Notes and Main Menu
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
3 - 1
3.1 Starting and Initializing
After switching on the MLT analyzer or analyzer module (in a platform or part of a NGA
network), the initialization procedure will be performed. A self control of the analyzer
modules or the analyzer is running. You can see a sequence of several displays. They
show the status of initialization, revision notes of the MLT software and the
tag:
If you press the F1 key during the initializing, you will reset the LCD brightness and
contrast to factory settings (see also section 7). Pressing the F3 key will abort the network
initializing. Then you will have no connection to any analyzer module. Only the menus of
the platform will be available.
At the end of the initializing procedure you can see the single component display of
channel one (see illustration on next page). It is the origin to all the other channels, menus
and submenus.
The instructions of the basic controls (chapter four) are all beginning with the single com-
ponent display. The actual display might differ from the shown one because the customer
can configure it according to his requirements (see section 5.1.8 p. 5-49 and section 7).
LCDReset Abort
F1 F2 F3 F4 F5
(C) 1998 FISHER-ROSEMOUNT Analytical
NGA-2000 Control Module/Version 3.2.1
Initializing Network
Initializing network interface