Filter
Top Products
Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
L
TM-U210 series
Specification
(STANDARD)
90 89
GS I n
[Name] Transmit printer ID
[Format] ASCII GS I n
Hex 1D 49 n
Decimal 29 73 n
[Range] 1 ≤ n ≤ 3, 49 ≤ n ≤ 51, 65 ≤ n ≤ 69
[Function] Transmits the printer ID specified by n as follows:
n Printer ID Specification ID (hexadecimal)
1, 49 Printer model ID TM-U200 series 0D
2, 50 Type ID See table below.
3, 51 ROM version ID ROM version
65 Firmware version Depends on firmware version.
66 Manufacturer EPSON
67 Printer name TM - U200
68 Serial number Depends on serial number.
69 Supporting multilingual
characters
Japan model: KANJI JAPANESE
China model: CHINA GB2312
Taiwan model: TAIWAN BIG-5
Thai model: THAI 3 PASS
n = 2, Type ID
Bit Off/On Hex Decimal Function
Off 00 0 Two-byte character codes not supported.
0
On 01 1 Two-byte character code supported.
Off 00 0 Autocutter not installed.
1
On 02 2 Autocutter installed.
2 - - - Undefined.
3 - - - Undefined.
4 Off 00 0 Not used. Fixed to Off.
5 - - - Undefined.
6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.
[Notes] • When DTR/DSR control is selected, the printer transmits only 1 byte (printer ID)
after confirming that the host is ready to receive data. If the host computer is not
ready to receive data, the printer waits until the host is ready.
• When XON/XOFF control is selected, the printer transmits only 1 byte (printer
ID) without confirming the condition whether the host is ready to receive data or
not.
• The printer ID is transmitted when the data in the receive buffer is developed.
Therefore, there may be a time lag between receiving this command and
transmitting the status, depending on the receive buffer status.
• When Auto Status Back (ASB) is enabled using GS a, the status transmitted by
GS I
II
I and the ASB status must be differentiated by using the table in Appendix E.