Filter
Top Products
Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
L
TM-U210 series
Specification
(STANDARD)
48 47
3.3 Switches and Buttons
3.3.1 Power switch
The power switch (rocker switch) is on the lower right front of the printer and turns the power on
or off.
3.3.2 Panel buttons
FEED button
[Type] Non-locking push button
The ESC c 5 command enables or disables the panel button. When disabled,
the FEED button will not function. However, when loading roll paper, if the paper
loading wait time has been set with GS z 0, the paper FEED button can be used
to feed the paper forward within the set time. If the FEED button is pressed while
the printer is in the on-line recovery wait state, the printer goes back online.
(For details, refer to command GS z 0.) The default settings differ for each
model type.
[Function] Feeds paper based the line feed amount set by the ESC 2 and ESC 3
commands.
3.3.3 DIP switches
1) RS-232 serial interface model
Table 3.3.1 DIP Switch 1
Default Settings
Switch No. Function ON OFF
A B D
1 Data reception
error
Ignored Prints “?”
2 Receive buffer
capacity
40 bytes ANK model:
1000 bytes
Multilingual model:
512 bytes
3 Handshaking XON/XOFF DTR/DSR
4 Word length 7 bit 8 bit
5 Parity check Yes No
6 Parity selection Even Odd
7 Baud rate selection 4800 bps 9600 bps
8 BUSY condition
•Receive
buffer-full
•Offline
•Receive buffer-full
Off