Filter
Top Products
Exatron 3000B
www.exatron.com 6-2 Chapter 6 Display Dictionary
1 LEFT STEP
The motor under consideration has moved one full step to the left.
1 RIGHT STEP
The motor under consideration has moved one full step to the right.
2 LEFT STEPS
The motor under consideration has moved two full steps to the left.
2 RIGHT STEPS
The motor under consideration has moved two full steps to the right.
ADJ Z SWITCH
The handler is in the Automatic Z Plunger Top Position Adjustment routine. At this point, the plunger has
moved up from the test site to its top position but the number of steps required to do so is not within
acceptable range (between 10 and 50 steps.) The Z Plunger Top Position switch itself must now be
moved so that the plunger will stop within the defined range. Please refer to Diagnostics Chapter 5 for
complete details.
ALIGN MOTORS ?
The operator may now "jog" any of the handler's motorized components by just one step using the keypad
keys as described below:
[1]
Jog the octoloader left
[3]
Jog the octoloader right
[4]
Jog the plunger up
[6]
Jog the plunger down
[7]
Jog the shuttle left
[9]
Jog the shuttle right
[0]
Turn all motors off: ALL MOTORS OFF
ALL MOTOR CHECK
Please refer to the Diagnostics section in Chapter 5 of this manual.
ALL MOTORS OFF
You have pressed the
[0]
key. The power to all motors is now OFF. You may realign or move any of the
motors manually. Press any handler controller button to continue.
ALL OUTPUTS FULL
The handler is waiting to sort a device, but all output tubes are full. Insert an empty tube into any of the
handler outputs which have flashing output cover LEDs.