Filter
Top Products
Exatron 3000B
www.exatron.com 4-2 Chapter 4 Handler Setup
3.
Turn the handler ON by pressing the RED mushroom style power button on the front of the
power supply.
NOTE: You may turn OFF the power to the handler at any time except within the first ten seconds
of having turned the handler ON. Always turn the handler OFF when you move either the handler
or the power supply.
NOTE: The handler uses a B
URR
-B
ROWN
Microterminal control panel, fully integrated into the
Model 3000B system. This microterminal unit has its own power-up procedures and set-up
conditions. Please refer to Section 3.2 SETUP Category Description of the Microterminal User's
Guide located in Chapter 10 of this manual for further information, if required.
4.
As the handler powers up, it will display its model number and current control program with
revision date. When calling in for assistance or software updates, please give this revision
date to E
XATRON
’s Customer Service Department.
5.
The handler's front panel microterminal controls are defined as:
[Enter]
= Starts operations; "sets" your selections
[Clear]
= FLUSH devices from handler
[Delete]
= Remove characters from display when making changes
[RUN]
=
READY TO RUN
Mode; also starts operations
[MANUAL]
=
MANUAL
Mode
[SET UP]
=
MOD SET UP ? YES/NO
CHANGE RAM ? YES/NO
[PAUSE]
=
HANDLER PAUSED
[TOTALS]
= Display output bin totals
[DIAGNOSTICS]
= Handler Diagnostic Mode
[0]
=
All MOTORS OFF
, then
[Enter]
=
ALIGN MOTORS ?
[1]
= Jog Octoloader 1 step left
[3]
= Jog Octoloader 1 step right
[4]
= Move plunger up 1 step
[6]
= Move plunger down 1 step
[7]
= Jog Shuttle 1 step left
[9]
= Jog Shuttle 1 step right
6.
The handler will now display
MOD SET UP ? NO
. From this point on, the handler controller
presents options and advises cycling status.
If you do not wish to make any changes to the handler's set up, press the
[ENTER]
button to
view the current settings. The display will scroll through the current settings for:
INTERFACE
STOP ON FAIL ON/OFF
PACKAGE TYPE
PLUNGE TO TEST SITE STEP SETTING
(Where applicable.)
OUTPUT TUBE FULL SETTING