Filter
Top Products
Exatron 3000B
www.exatron.com 6-16 Chapter 6 Display Dictionary
PICK INTERFACE?
The handler is asking you to select one of the following four interface choices:
[1] = HANDLER PORT.
[2] = EXATRON SUPER
. Use this interface when the handler is being controlled by a PC
using E
XATRON
-supplied software.
[4] = PROGRAM RS-232
. Use this interface to connect the handler directly to the programmer
according to the following application
notes: a - The programmer must be in REMOTE CONTROL.
b - The programmer must be set up manually using the
programmer's terminal software.
c - There is no E
XATRON
PC control with this interface.
[5] = EXATRON RS-232.
[Enter]
Sets your selection.
[Clear]
Resets to the top of the handler's
PICK INTERFACE?
loop.
PICK PACKAGE ?
The handler is asking you to select one of the following seven package-type cycles while in the
MOD SET UP ? YS
Mode:
[1] = RUN PLCC PLUNGE
[2] = RUN DIPS PLUNGE
[3] = RUN SOIC PLUNGE
[5] = PLCC SWING HEAD
[6] = RUN DIPS - 2800
[7] = RUN TYPE3 SOIC
[8] = RUN SOT
[Enter]
Sets your selection.
[Clear]
Resets to the top of the handler's
PICK PACKAGE ?
loop.
PICK UP ERROR 1
The handler has failed to pick up the device at the start of the pick-up test cycle. This message refers to
Type 2 "Swing Head" PLCC Changeover Kits only.
PICK UP ERROR 2
The handler has completed a test. It has failed to pick up the tested device and place it back into the
handler's track. This message refers to Type 2 "Swing Head" PLCC Changeover Kits only.
PLCC SWING HEAD
This message is displayed during
MOD SET UP ? YS
Mode. It is one of the package-type settings which
may be selected if your handler has a PLCC Swing Head Changeover Kit. These kits may be referred to
as "Type 2" PLCC Kits.
PLEASE WAIT
This message is displayed while the handler is powering up. No action is required.