Filter
Top Products
112 Fortinet Inc.
Configuring traffic logging for connections to an interface Network configuration
Configuring traffic logging for connections to an interface
1 Go to System > Network > Interface.
2 Select Modify for the interface for which to configure logging.
3 Select Log to record log messages whenever a firewall policy accepts a connection to
this interface.
4 Select OK to save your changes.
Figure 1: Configuring the internal interface
Configuring the external interface with a static IP address
1 Go to System > Network > Interface.
2 For the external interface, select Modify .
3 Set Addressing mode to Manual.
4 Change the IP address and Netmask as required.
5 Select OK to save your changes.
Configuring the external interface for DHCP
Use the following procedure to configure the external interface to use DHCP. This
configuration is required if your ISP uses DHCP to assign the IP address of the
external interface.
1 Go to System > Network > Interface.
2 For the external interface, select Modify .
3 Set Addressing mode to DHCP and select OK to change to DHCP mode.
Both the IP address and Netmask change to 0.0.0.0.