Filter
Top Products
IPSec VPN Viewing VPN tunnel status
FortiGate-100 Installation and Configuration Guide 205
Monitoring and Troubleshooting VPNs
This section provides a number of general maintenance and monitoring procedures
for VPNs.
This section describes:
• Viewing VPN tunnel status
• Viewing dialup VPN connection status
• Testing a VPN
Viewing VPN tunnel status
You can use the IPSec VPN tunnel list to view the status of all IPSec AutoIKE key
VPN tunnels. For each tunnel, the list shows the status of each tunnel as well as the
tunnel time out.
To view VPN tunnel status:
1 Go to VPN > IPSEC > AutoIKE Key.
The Status column displays the status of each tunnel. If Status is Up, the tunnel is
active. If Status is Down, the tunnel is not active.
The Timeout column displays the time before the next key exchange. The time is
calculated by subtracting the time elapsed since the last key exchange from the
keylife.
Figure 27: AutoIKE key tunnel status
Viewing dialup VPN connection status
You can use the dialup monitor to view the status of dialup VPNs. The dialup monitor
lists the remote gateways and the active VPN tunnels for each gateway. The monitor
also lists the tunnel lifetime, timeout, proxy ID source, and proxy ID destination for
each tunnel.