Filter
Top Products
3-23
Collation in Printer: Sets whether job collation is handled by the printer or by the
computer.This setting should match the Collation Mode setting on the printer’s
Configuration menu.
Installable Options controls the following settings:
Additional Trays: Sets whether additional trays are present or not.
Envelope Feeder: Sets whether the envelope feeder is present or not.
Offset Bin: Sets whether the upper output bin is present or not.
Duplex Unit: Sets whether the duplex unit is present or not.
Internal Hard Disk: Sets whether an internal hard disk is present or not.
Collation Mode: Sets ‘collation in printer’ mode (i.e. - whether the printer handles job
collation, or if each copy is sent individually by the print driver). This setting should
match the “Collation” setting on the printer’s front panel Configuration menu.
Paper Sizes: Sets whether US and International sizes are made available, or just US or
International.
VM Option: Sets the amount of memory installed in the printer.
To change any option in Device Options, click on the option on the list. The “Change
Setting” section at the bottom of the page will display the option you chose. You can then
change the setting from the pull-down menu. The new setting should then appear on the
list in the upper window. Click Apply and OK to accept when all changes are made.
The final tab in the Properties windows is
PostScript. This section contains settings for
PostScript output format, PostScript headers, error information and timeout values. The default
settings in this category should suit the needs of most users.
Changes made within the Driver Properties window will be set as printer defaults unless
changed by returning to Properties.