Filter
Top Products
6-10
7. Input/Output (continued)
• NetWare*: Sets the built-in Novell NetWare support to Disabled or Enabled.
• RS-232 Baud Rate: Sets the baud rate for the RS-232 Serial interface.
Default is 9600 bps. This setting should match the COM port setting on the
PC.
• RS-232 Data Bits: Sets the data bits for the RS-232 Serial interface. Default
is 8 bits. This setting should match the COM port setting on the PC.
• RS-232 Stop Bits: Sets the stop bits for the RS-232 Serial interface. Default is
1 bit. This setting should match the COM port setting on the PC.
• RS-232 Parity: Sets the parity for the RS-232 Serial interface. Default is
None. This setting should match the COM port setting on the PC.
• RS-232 Flow Control: Sets the flow control for the RS-232 Serial interface.
Default is Hardware. This setting should match the COM port setting on the
PC.
Note: Changes made to items marked with an asterisk (*) will not take effect
until the printer is restarted.
8. Resets
• Restore Defaults: Sets all menu items in all menus back to their factory
defaults. This change requires an immediate restart to take effect.
• Restore Network: Sets all network items back to their factory defaults. This
change will not take effect until the printer is restarted.
• Initialize Disk: Initializes the printer’s internal hard disk. This will remove any
downloaded fonts and/or held jobs from the disk. This change requires an
immediate restart to take effect. This menu item only appears if the printer is
equipped with an internal hard drive.