Filter
Top Products
1-41
Additional Installation Notes
Configuring Startup Page
The Elite 21 printer will print a Configuration Page each time that the printer is
started up. This page serves as a hardware test at startup, to make sure that
all printer systems are working properly and that the printer is able to print a
page successfully. This page also provides a listing of all user-configurable
printer parameters and their current settings, which can be useful in printer
troubleshooting.
Some users, especially those who restart their printer often, may wish to
disable this page. The steps for disabling the Startup Page are as follows:
• Make sure the printer’s display is reading “Ready.”
• Press Menu up or down until “Configuration” appears.
• Press Item up or down until “Startup Page” appears.
• Press Value up or down until “Disabled” appears.
• Press Select to accept the new setting.
• Press Menu up or down until the display returns to “Ready.”
The Startup Page will not print out the next time the printer is started.
Note: The factory default for the Startup Page is Enabled, so if the printer is
reset to defaults using the “Restore Defaults” feature in the Resets menu, the
page will be re-enabled. Follow the steps above to disable to page again in this
case.
Memory Configuration (Elite 21 DN and Elite 21 SE only)
The GCC Elite 21 Series uses a single PostScript Printer Description (PPD) file
for all three Elite 21 models. As a result, the default memory setting for the
printer is set to 16MB (the minimum amount of shipping RAM for the series)
within the PPD file. Users of the Elite 21 DN and Elite 21 SE models should
follow the instructions found on Page 78 to assure that the printer driver is set
to use the appropriate amount of memory. The Elite 21 DN ships with 32MB of