Filter
Top Products
Configuration Menu 104
Management Networks configuration
Command: /cfg/sys/access/mgmt
[Management Networks Menu]
add - Add mgmt network definition
rem - Remove mgmt network definition
cur - Display current mgmt network definitions
The following table describes the Management Networks Configuration menu options.
Table 97 Management Networks Configuration menu options
Command Description
add <IP address> <IP mask> Adds a defined network through which switch access is allowed through
Telnet, SNMP, RIP, or the browser-based interface. A range of IP addresses is
produced when used with a network mask address. Specify an IP address
and mask address in dotted-decimal notation.
rem <IP address> <IP mask> Removes a defined network, which consists of a management network
address and a management network mask address.
cur Displays the current management networks parameters.
User Access Control configuration
Command: /cfg/sys/access/user
[User Access Control Menu]
uid - User ID Menu
usrpw - Set user password (user)
opw - Set operator password (oper)
admpw - Set administrator password (admin)
cur - Display current user status
The following table describes the User Access Control menu options.
Table 98 User Access Control Configuration menu options
Command Description
uid <1-10> Displays the User ID Menu for the selected user.
eject <1-10> Ejects the selected user from the switch.
usrpw <1-128
characters>
Sets the user (user) password (maximum 128 characters). The user has no direct
responsibility for switch management. He or she can view switch status information and
statistics, but cannot make any configuration changes.
opw <1-128
characters>
Sets the operator (oper) password (maximum 128 characters). The operator manages all
functions of the switch. He or she can view all switch information and statistics and can reset
ports or the entire switch.
admpw <1-128
characters>
Sets the administrator (admin) password (maximum 128 characters). The super user
administrator has complete access to all menus, information, and configuration commands on
the switch, including the ability to change both the user and administrator passwords.
cur Displays the current user status.