Filter
Top Products
Maintenance Menu 169
The Miscellaneous Debug Menu displays trace buffer information about events that can be helpful in understanding
GbE2 Interconnect Switch operation. You can view the following information using the Debug Menu:
• Events traced by the management processor (MP)
• Events traced to a buffer area when a reset occurs
If the GbE2 Interconnect Switch resets for any reason, the management processor (MP) trace buffer is saved into the
snap trace buffer area. The output from these commands can be interpreted by HP technical support.
The following table describes the Miscellaneous Debug Menu options:
Table 197 Miscellaneous Debug Menu options
Command Usage
tbuf Displays the management processor trace buffer. Header information similar to the following is
shown:
MP trace buffer at 13:28:15 Fri May 25, 2002; mask: 0x2ffdf748
The buffer information is displayed after the header.
snap Displays the management processor snap (or post-mortem) trace buffer. This buffer contains
information traced at the time that a reset occurred.
clrcfg Deletes all flash configuration blocks. The next time the GbE2 Interconnect Switch is rebooted,
it returns to the factory default settings.
ARP cache options
Command: /maint/arp
[Address Resolution Protocol Menu]
find - Show a single ARP entry by IP address
port - Show ARP entries on a single port
vlan - Show ARP entries on a single VLAN
addr - Show ARP entries for switch's interfaces
dump - Show all ARP entries
add - Add a permanent ARP entry
del - Delete an ARP entry
clear - Clear ARP cache
The following table describes the Address Resolution Protocol Menu options:
Table 198 Address Resolution Protocol Menu options
Command Usage
find <IP address> Shows a single ARP entry by IP address. For example,
192.4.17.35
port <port number> Shows ARP entries on a single port.
vlan <1-4095> Shows ARP entries on a single VLAN.
addr Shows the list of IP addresses that the switch will respond to
for ARP requests.
dump Shows all ARP entries.
add <IP address> <MAC address> <1-4095>
<port number>
Adds a single ARP entry to switch memory.
del <IP address> Removes a single ARP entry from switch memory.
clear Clears the entire ARP list from GbE2 Interconnect Switch
memory.
NOTE: To display all ARP entries currently held in the GbE2 Interconnect Switch, or a portion according to one
of the options listed on the menu above (find, port, vlan, dump), see the “ARP information” section of the
“Information Menu” chapter.