Filter
Top Products
Configuration Menu 133
Table 145 RIP Interface Configuration Menu options
Command Description
split disable|enable Enables or disables split horizon. The default value is enabled.
trigg disable|enable Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The
default value is
disabled.
mcast disable|enable Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is
enabled.
default disable|enable When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When disabled,
the switch rejects RIP default routes. The default value is
disabled.
metric <1-15> Configures the route metric, which indicates the relative distance to the
destination. The default value is
1.
auth none|password Configures the authentication type. The default is none.
key Configures the authentication key password.
enable Enables this RIP interface.
disable Disables this RIP interface.
cur Displays the current RIP configuration.
RIP Route Redistribution configuration
Command: /cfg/l3/rip/redist fixed|static|ospf|eospf
[RIP Redistribute Fixed Menu]
add - Add rmap into route redistribution list
rem - Remove rmap from route redistribution list
export - Export all routes of this protocol
cur - Display current route-maps added
The following table describes the RIP Route Redistribute Menu options.
Table 146 RIP Interface Configuration Menu options
Command Description
add <1-32> <1-32>|all Adds selected routing maps to the RIP route redistribution list. To add all the 32
route maps, enter
all. To add specific route maps, enter routing map numbers
one per line, NULL at the end.
This option adds a route map to the route redistribution list. The routes of the
redistribution protocol matched by the route maps in the route redistribution list
will be redistributed.
remove <1-32> <1-32>|all Removes the route map from the RIP route redistribution list.
Removes routing maps from the list. To remove all 32 route maps, enter
all.
To remove specific route maps, enter routing map numbers one per line, NULL
at end.
export <1-15>|none Exports the routes of this protocol in which the metric and metric type are
specified. To remove a previous configuration and stop exporting the routes of
the protocol, enter
none.
cur Displays the current RIP route redistribute configuration.