Filter
Top Products
Configuration Menu 122
Layer 2 IP Trunk Hash configuration
Command: /cfg/l2/thash/set
[set IP Trunk Hash Settings Menu]
smac - Enable/disable smac hash
dmac - Enable/disable dmac hash
sip - Enable/disable sip hash
dip - Enable/disable dip hash
cur - Display current trunk hash setting
Trunk hash parameters are set globally for the GbE2 Interconnect Switch. You can enable one or two parameters, to
configure any of the following valid combinations:
• SMAC (source MAC only)
• DMAC (destination MAC only)
• SIP (source IP only)
• DIP (destination IP only)
• SIP + DIP (source IP and destination IP)
• SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration Menu options.
Table 125 IP Trunk Hash Set Menu options
Command Description
smac enable|disable Enable or disable trunk hashing on the source MAC.
dmac enable|disable Enable or disable trunk hashing on the destination MAC.
sip enable|disable Enable or disable trunk hashing on the source IP.
dip enable|disable Enable or disable trunk hashing on the destination IP.
cur Display current trunk hash configuration.
Link Aggregation Control Protocol configuration
Command: /cfg/l2/lacp
[LACP Menu]
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner info
port - LACP port Menu
cur - Display current LACP configuration
The following table describes the LACP Configuration Menu options.
Table 126 LACP Configuration Menu options
Command Description
sysprio <1-65535> Defines the priority value (1 through 65535) for the switch. Lower
numbers provide higher priority. The default value is 32768.
timeout short|long Defines the timeout period before invalidating LACP data from a remote
partner. Choose
short (3 seconds) or long (90 seconds). The default
value is
long.
NOTE: HP recommends that you use a timeout value of long, to reduce LACPDU processing. If your switch’s CPU
utilization rate remains at 100% for periods of 90 seconds or more, consider using static trunks instead of LACP.
port <port number> Displays the LACP Port menu.
cur Display current LACP configuration.