Filter
Top Products
Configuration Menu 110
ACL Port Re-Mark In-Profile configuration
Command: /cfg/port <port number>/aclqos/re-mark <1-63>/inprof
[Re-marking - In Profile Menu]
up1p - Set Update User Priority Menu
updscp - Set the update DSCP
reset - Reset in profile settings
cur - Display current settings
The following table describes the ACL Port Re-Mark In-Profile Configuration Menu options.
Table 107 ACL Port Re-Mark In-Profile Configuration Menu options
Command Description
up1p Displays the Re-Mark In-Profile Update User Priority Menu.
updscp <0-63> Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected value.
reset Resets the update DSCP parameters to their default values.
cur Displays current Re-Mark In-Profile parameters.
Re-Mark Update User Priority configuration
Command: /cfg/port <port number>/aclqos/re-mark <1-63>/inprof/up1p
[Update User Priority Menu]
value - Set the update user priority
utosp - Enable/Disable use of TOS precedence
reset - Reset in profile up1p settings
cur - Display current settings
The following table describes the Update User Priority Configuration Menu options.
Table 108 ACL Port Update User Priority Configuration Menu options
Command Description
value <0-7> Defines 802.1p value. The value is the priority bits information in the packet
structure.
utosp enable|disable Enable or disable mapping of TOS (Type of Service) priority to 802.1p priority for
In-Profile packets. When enabled, the TOS value is used to set the 802.1p value.
reset Resets UP1P settings to their default values.
cur Displays current Re-Mark In-Profile User Priority parameters.
ACL Port Re-Mark Out-of-Profile configuration
Command: /cfg/port <port number>/aclqos/re-mark <1-63>/outprof
[Re-marking - Out Of Profile Menu]
updscp - Set the update DSCP
reset - Reset out of profile settings
cur - Display current settings
The following table describes the Re-Mark Out-of-Profile Configuration Menu options.
Table 109 ACL Port Re-Mark Out-of-Profile Configuration Menu options
Command Description
updscp <0-63> Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected value. The
switch sets the DSCP value on Out-of-Profile packets.
reset Resets the update DSCP parameters for Out-of-Profile packets to their default values.
cur Displays current Re-Mark Out-of-Profile parameters.