Filter
Top Products
Configuration Menu 160
Restoring the active GbE2 Interconnect Switch configuration
Command: /cfg/gtcfg <TFTP server> <filename>
When the gtcfg command is used, the active configuration will be replaced with the commands found in the specified
configuration file. The file can contain a full GbE2 Interconnect Switch configuration or a partial configuration. The
configuration loaded using gtcfg is not activated until the apply command is used. If the apply command is found in
the configuration script file loaded using this command, the apply action will be performed automatically.
To start the GbE2 Interconnect Switch configuration download, at the Configuration# prompt, enter:
Configuration# gtcfg <TFTP server> <filename>
Where <TFTP server> is the TFTP server IP address or hostname and <filename> is the name of the target script
configuration file.
NOTE: The GbE2 Interconnect Switch supports three configuration files: active, backup, and factory. See the
“Selecting a configuration block” section in the “Boot Options Menu” chapter for information on how to set
which configuration file to use upon boot up.