Filter
Top Products
Information Menu 34
(UNK), the MAC address has not yet been learned by the GbE2 Interconnect Switch, but has only been seen as a
destination address. When an address is in the unknown state, no outbound port is indicated.
Clearing entries from the forwarding database
To delete a MAC address from the forwarding database (FDB), see the “Static FDB configuration” section in the
“Configuration Menu” chapter. To clear the entire forwarding database (FDB), see the “Forwarding Database
options” section in the “Maintenance Menu” chapter.
Link Aggregation Control Protocol information
Command: /info/l2/lacp
[LACP Menu]
aggr - Show LACP aggregator information for the port
port - Show LACP port information
dump - Show all LACP ports information
The following table describes the Link Aggregation Control Protocol Menu options.
Table 20 LACP information
Command Usage
aggr Displays LACP aggregator information for the port.
port Displays LACP information for the port.
dump Displays all LACP information parameters.
LACP dump
Command: /info/l2/lacp/dump
>> LACP# dump
port lacp adminkey operkey selected prio attached trunk
aggr
----------------------------------------------------------------------
1 off 1 1 n 32768 -- --
2 off 2 2 n 32768 -- --
3 off 3 3 n 32768 -- --
4 off 4 4 n 32768 -- --
5 off 5 5 n 32768 -- --
6 off 6 6 n 32768 -- --
7 off 7 7 n 32768 -- --
8 off 8 8 n 32768 -- --
…
LACP dump includes the following information for each port in the GbE2 Interconnect Switch:
• lacp—Displays the port’s LACP mode (active, passive, or off).
• adminkey—Displays the value of the port’s adminkey.
• operkey—Shows the value of the port’s operational key.
• selected—Indicates whether the port has been selected to be part of a Link Aggregation Group.
• prio—Shows the value of the port priority.
• attached aggr—Displays the aggregator associated with each port.
• trunk—This value represents the LACP trunk group number.