Filter
Top Products
Configuration Menu 130
[IP Route Map 1 Menu]
alist - Access List number
aspath - AS Filter Menu
ap - Set as-path prepend of the matched route
lp - Set local-preference of the matched route
metric - Set metric of the matched route
type - Set OSPF metric-type of the matched route
prec - Set the precedence of this route map
weight - Set weight of the matched route
enable - Enable route map
disable - Disable route map
delete - Delete route map
current - Display current route map configuration
Routing maps control and modify routing information. The map number (1-32) represents the routing map you wish to
configure.
The following table describes the Route Map Configuration Menu options.
Table 141 Route Map Configuration Menu options
Command Description
alist <1-8> Displays the Access List menu.
aspath <1-8> Displays the Autonomous System (AS) Filter menu.
ap <AS number> [<AS number>]
[<AS number>]|none
Sets the AS path preference of the matched route. One to three path
preferences can be configured.
lp <0-4294967294>|none Sets the local preference of the matched route, which affects both inbound
and outbound directions. The path with the higher preference is preferred.
metric <0-4294967294>|none Sets the metric of the matched route.
type 1|2|none Assigns the type of OSPF metric. The default is type 1.
• Type 1—External routes are calculated using both internal and external
metrics.
• Type 2—External routes are calculated using only the external metrics.
Type 2 routes have more cost than Type 2.
• none—Removes the OSPF metric.
prec <1-256> Sets the precedence of the route map. The smaller the value, the higher the
precedence. Default value is 10.
weight <0-65534>|none Sets the weight of the route map.
enable Enables the route map.
disable Disables the route map.
delete Deletes the route map.
cur Displays the current route configuration.