Filter
Top Products
Configuration Menu 149
The following table describes the VRRP Tracking Configuration Menu options.
Table 169 VRRP Tracking Configuration Menu options
Command Description
vrs <0-254> Defines the priority increment value (0 through 254) for virtual routers in master mode detected on
this switch. The default value is 2.
ifs <0-254> Defines the priority increment value (0 through 254) for active IP interfaces detected on this
switch. The default value is 2.
ports <0-254> Defines the priority increment value (0 through 254) for active ports on the virtual router’s VLAN.
The default value is 2.
cur Displays the current configuration of priority tracking increment values.
Quality of Service configuration
Command: /cfg/qos
[QOS Menu]
8021p - 802.1p Menu
Use the Quality of Service (QoS) menus to configure the IEEE 802.1p priority value of incoming packets. This allows
you to differentiate between various types of traffic, and provide different priority levels. The following table describes
the QoS Configuration Menu options.
Table 170 QoS Configuration Menu options
Command Description
8021p Displays 802.1p configuration menu.
QoS 802.1p configuration
Command: /cfg/qos/8021p
[802.1p Menu]
priq - Set priority to COS queue mapping
qweight - Set weight to a COS queue
numcos - Set number of COS queue
cur - Display current 802.1p configuration
This feature provides the GbE2 Interconnect Switch the capability to filter IP packets based on the IEEE 802.1p bits in
the packet's VLAN header. The 802.1p bits specify the priority that you should give to the packets while forwarding
them. The packets with a higher (non-zero) priority bits are given forwarding preference over packets with numerically
lower priority bits value.
The following table describes the 802.1p Configuration Menu options.
Table 171 802.1p Configuration Menu options
Command Description
priq <0-7> <0-7> Maps the 802.1p priority of to the Class of Service queue (COSq) priority. Enter the
802.1p priority value (0-7), followed by the Class of Service queue (0-7) that handles the
matching traffic.
qweight <0-7> <0-15> Configures the weight of the selected Class of Service queue (COSq). Enter the queue
number (0-7), followed by the scheduling weight (0-15).
numcos 2|8 Sets the number of Class of Service queues for switch ports. Default is 8.
cur Displays the current 802.1p parameters.
Access Control configuration
Command: /cfg/acl